SSPC Guide 24
- standard by Society for Protective Coatings, 03/12/2018
- Soluble Salt Testing Frequency and Locations on New Steel Surfaces
- Category: SSPC
$179.00
$90.00
Full Description
1. Scope
1.1 This guide is intended to assist owners and specifiers to determine the location of test sites and frequency of testing for measuring the amount of soluble salt on:
1.3 Units of Measure: This standard provides both U.S. Customary units and IEEE/ASTM SI 10(1), "American National Standard for Metric Practice" International System Units (SI) units. The measurements are not exact equivalents; therefore, each system must be used independently of the other, without combining in any way. This guide uses U.S. Customary units and provides the SI conversions shown in parentheses for information only.
1.1 This guide is intended to assist owners and specifiers to determine the location of test sites and frequency of testing for measuring the amount of soluble salt on:
- Uncoated steel surfaces prior to the first application of a protective coating.
- Shop coated steel (primer, pre-construction primer) that will subsequently receive additional coats to complete a coating system.
1.3 Units of Measure: This standard provides both U.S. Customary units and IEEE/ASTM SI 10(1), "American National Standard for Metric Practice" International System Units (SI) units. The measurements are not exact equivalents; therefore, each system must be used independently of the other, without combining in any way. This guide uses U.S. Customary units and provides the SI conversions shown in parentheses for information only.
Product Details
- Published:
- 03/12/2018
- Number of Pages:
- 5
- File Size:
- 1 file , 950 KB
- Note:
- This product is unavailable in Ukraine, Belarus, Russia